Tria
Blow Moulding

Blow Moulding

  1. Home
  2. Technologies and products
  3. Technologies
  4. Blow Moulding

Full range of granulators for small bottles, tanks and jerry cans to 200 lt, coex fuel tanks 15 kg, IBC container, without pre-cutting.
In-line grinding of pieces from blow moulding and runners up to 180°C.
Start-up grinding up to 23.000 bottles/hr of 0,75 lt, without fly-back.

More information

Regrind quality material

Blow Moulding

Homogeneous and uniform regrind constantly produced. Mechanical and physical properties of plastics unchanged. Increased gripping ability for a bigger productivity thanks to the cutting chamber section, especially for voluminuos and light small blow mouldings.

Efficient solutions

Blow Moulding

Water cooling, side discs, antiwear chamber, open rotor and specific chamber section allow in line grinding of pieces from blow molding and top&tails up to 180°C.

Energy efficiency

Blow Moulding

Low running cost expressed in kWh/kg. Reactive power cosϕ reduced to minimum thus having a direct impact on hourly energy cost. Combined effect with different cutting angles (arrow and scissor) to minimize cutting effort.

Easy operation and maintenance

Blow Moulding

Reduced maintenance frequency and downtime by advance engineering design. Safety of operator during use and maintenance.

Applications

Bottles Bottles
Jerrycans Jerrycans
Fuel tanks Fuel tanks
Drums up to 220 lt Drums up to 220 lt
IBC container IBC container
BM SERIES

BM SERIES

Granulators dedicated to the recovery of blow moulding scraps: runners, blown pieces, in-line parison at high temperatures. Off-line grinding of preforms and blown pieces. Suitable for moulds or bulky and light thermoformed scraps.